User manual
Table Of Contents
- CONTENTS
- GENERAL VIEW
- INTRODUCTION
- INSTALLATION
- GRYPHON™ MX30 SYSTEM AND NETWORK LAYOUTS
- CONFIGURATION
- RS232 PARAMETERS
- USB PARAMETERS
- WEDGE PARAMETERS
- PEN EMULATION
- DATA FORMAT
- POWER SAVE
- READING PARAMETERS
- DECODING PARAMETERS
- CODE SELECTION
- ADVANCED FORMATTING
- RADIO PARAMETERS
- REFERENCES
- TECHNICAL FEATURES
- A HOST CONFIGURATION STRINGS
- B CODE IDENTIFIER TABLE
- C HEX AND NUMERIC TABLE
Enter Configuration Exit and Save Configuration
Ì$+;Î
CODE SELECTION
Ì$
-
?Î
Codabar ABC Forced Concatenation
enable Codabar ABC with forced concatenation
ÌAD2321Î
non start/stop char ut transmission acter equality control b
CODE LENGTH (optional)
The code length selection is valid for the entire Codabar family
4 numbers for the code length where:
set code length
= minimum code length.
= maximum code length.
Read the code +
First 2 digits
Second 2 digits
ÌAD*AÎ
The maximum code length is 99 characters.
The minimum code length must alway
Exam 1 to 9 digits in the code. 1010 = 10 digit code length only.
START/STOP CHARACTER CASE IN TRANSMISSION
s be less than or equal to the maximum.
p mles: 0199 = variable fro 9
The start/stop character case selections below are valid for the entire Codabar family:
stop characters in lower case
ÌADA0_Î
transmit start/stop characters in
ÌADA1cÎ
transmit start/
upper case
103