User manual

Enter Configuration Exit and Save Configuration
Ì$+;Î
WEDGE
Ì$
-
?Î
51
f Select the key modifier:
Ì01Î
none (single key)
Ì12Î
shift key
Ì23Î
ctrl key
Ì45Î
alt key
g Read the three numeric values for the scancode of the key to associate with the new
character. Repeat steps 4 and 5 for a 4-key sequence.
h Read the Exit & Save Configuration barcode at the top of this page.
Determining a Key's Scancode (for Wedge interface only)
Since scancode keymaps are not readily available for all the different supported keyboards, a
Return Scancode command is provided. To determine the scancode of the desired character for
your keyboard; connect and configure your barcode reader to the desired host device, read the
code below and press the key. The scancode of the pressed key will be sent to the host and the
reader exits this mode. Repeat the procedure to determine other scancodes.
Ì$+FB2$-fÎ
Return Scancode
NOTE
The reader will signal an incomplete read tone. This is normal and not an
error. Proceed to press a keyboard key to determine the scancode.