User manual

GRYPHON™ BT CORDLESS READING SYSTEMS
8
To disconnect the Host Interface cable, insert a paper clip or other similar object into
the hole corresponding to the Host connector on the body of the cradle. Push down on
the clip while unplugging the cable. Refer to the following figure:
Disconnecting the Cable
3.2 SETTING UP GRYPHON™ BT WITH OM-GRYPHON™ BT
Follow the given procedure to set communication between Gryphon™ BT and
OM-Gryphon™ BT.
Read the restore default parameters code below.
Restore Gryphon™ BT Default
1.
Ì$+$*oÎ
Read the Bind code to pair the Gryphon™ BT to the OM-Gryphon™ BT
cradle.
The cradle will refuse connection to any previously bound reader. It is
however, advised to unbind any previously bound reader.
Bind
2.
Ì$+RN0$-IÎ
The blue LED on the Gryphon™ BT will blink; the reader is ready to be
positioned onto the cradle.
3.
Firmly position the reader onto the OM-Gryphon™ BT cradle within 4
seconds, a beep will be emitted, signaling that the OM-Gryphon™ BT cradle
has been paired to the Gryphon™ BT.