User manual

INITIAL SETUP
7
3 INITIAL SETUP
This procedure allows setting up the reader to operate with the default settings.
Two different procedures are available according to the type of application you are
working with:
− Gryphon™ BT paired to the OM-Gryphon™ BT (follow procedure in par. 3.2);
− Gryphon™ BT communicating with a Bluetooth
®
device (follow procedure in
par. 3.3).
Whenever
you need to change the default values refer to par. 4.3.
3.1 OM-GRYPHON™ BT CABLE CONNECTIONS
The OM-Gryphon™ BT incorporates a multi-standard interface which can be
connected to a Host by simply plugging a USB, RS232, Wedge emulation or Pen
emulation cable into the Host connector, placed on the base of the cradle.
In addition the cradle must be connected to an external power supply.
To connect the OM-Gryphon™ BT:
1. Connect the OM-Gryphon™ BT to the appropriate interface cable which must be
simply plugged into the Host connector on the base of the cradle.
2. Connect the cradle to an external power supply, see the figure below.
Bottom View
Host Interface Cable
Power Supply