User manual

SYSTEM MANAGEMENT COMMANDS
157
6.4 CRADLE CHARGING MANAGEMENT
Battery selection is required only when the Gryphon™ BT reader has an Alkaline
battery and you want to use the OM-Gryphon™ BT or C-Gryphon either for serial
configuration, software upgrades or to hold Gryphon™ BT. Since this type of battery
must not be charged it is necessary to disable the cradle charge function by following
the procedure:
1.
With the Gryphon™ BT read the following code:
Alkaline
Ì$+RN4$-]Î
The blue LED on the Gryphon™ BT will blink, signaling the reader has
accepted the command.
2.
Place the reader onto the charger within 4 seconds. The blue LED turns off
and a short beep is emitted
To enable the charge function repeat step 1 and 2 substituting the "Alkaline" code
with the following one:
NiMh/NiCd
Ì$+RN6$-gÎ
CAUTION
Attempts to charge Alkaline batteries could cause leakage of liquid,
generation of heat or, in extreme cases, explosion. If using Alkaline
batteries, carefully follow the procedure above to avoid damage.