User Manual

LED and Beeper Indications
36 Gryphon™ I GBT4102
Green Spot is on
continuously
While in Stand
Mode or Trigger
Stand Mode the
green spot shall
be on while in
stand watch
state.
N/A N/A
Green Spot
a
flashes
momentarily
Upon successful
read of a label,
the software
shall turn the
green spot on for
the time speci-
fied by the con-
figured value.
N/A N/A
Programming Mode - The following indications ONLY occur when the
reader is in Programming Mode.
Label Program-
ming Mode
Entry
A valid program-
ming label has
been scanned.
LED blinks con-
tinuously
Reader sounds
four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of
Label
A label has been
rejected.
N/A
Reader sounds
three times at
lowest frequency
and current vol-
ume.
Label Program-
ming Mode
Acceptance of
Partial Label
In cases where
multiple labels
must be scanned
to program one
feature, this indi-
cation acknowl-
edges each
portion as it is
successfully
scanned.
N/A
Reader sounds
one short beep
at highest fre-
quency and cur-
rent volume.
Label Program-
ming Mode
Acceptance of
Programming
Configuration
option(s) have
been success-
fully pro-
grammed via
labels and the
reader has exited
Programming
Mode.
N/A
Reader sounds
one high fre-
quency beep and
4 low frequency
beeps followed
by reset beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has
been scanned.
N/A
Reader sounds
two times at low
frequency and
current volume.
a. Except when in sleep mode or when a Good Read LED Duration other
than 00 is selected
INDICATION DESCRIPTION LED BEEPER