User Manual
Table Of Contents
- Gryphon™ I GBT4102
- Table of Contents
- Setting Up the Reader
- Configuring the Base Station
- Connecting the Base Station
- Charging the Batteries
- Linking the Reader
- Selecting the Interface Type
- Programming
- Stand Detection
- Technical Specifications
- LED and Beeper Indications
- Error Codes
- Base Station Indications
- Cleaning Procedure
- Datalogic Limited Factory Warranty
- Support Through the Website
- Ergonomic Recommendations
- Keypad
Selecting the Interface Type
Quick Reference Guide 17
Unlike some other programming features and
options, interface selections require that you
scan only one programming barcode label. DO
NOT scan an ENTER/EXIT barcode prior to
scanning an interface selection barcode.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while
in this state, pull the trigger and hold for 5
seconds. The scanner will change to a state
that allows programming with barcodes.
RS-232
RS-232 standard interface
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS232-WN
RS-232 for use with OPOS/UPOS/JavaPOS
Select RS-232 OPOS
USB Com to simulate RS-232 standard interface
Select USB-COM-STD
a