User Manual
Table Of Contents
- Gryphon™ I GBT4102
- Table of Contents
- Setting Up the Reader
- Configuring the Base Station
- Connecting the Base Station
- Charging the Batteries
- Linking the Reader
- Selecting the Interface Type
- Programming
- Stand Detection
- Technical Specifications
- LED and Beeper Indications
- Error Codes
- Base Station Indications
- Cleaning Procedure
- Datalogic Limited Factory Warranty
- Support Through the Website
- Ergonomic Recommendations
- Keypad
Selecting the Interface Type
16 Gryphon™ I GBT4102
System and Network Layout
Typical Setup with Cradle and Host
Figure 7. Reader Layout
Selecting the Interface Type
Upon completing the physical connection between the
reader and its host, proceed directly to Interface Selection
on page 16 for information and programming for the
interface type the reader is connected to (for example: RS-
232, Keyboard Wedge, USB, etc.) and scan the appropriate
barcode to select your system’s correct interface type.
Interface Selection
Each reader model will support one of the following sets
of host interfaces:
General Purpose Models —
RS-232, RS-232 OPOS, USB, Key-
board Wedge, Wand.
Retail Point of Sale Models —
RS-232, RS-232 OPOS, USB,
IBM 46XX (with accessory cable).
Information and programming options for each interface
type are provided in this section.
Configuring the Interface
Scan the programming barcode which selects the appro-
priate interface type matching the system the reader will
be connected to.
If you need to customize additional settings and features
associated with that interface, proceed to the correspond-
ing chapter in the Gryphon™ I PRG.