User Manual

Charging the Batteries
8Gryphon™ I GBT4102
Charging the Batteries
To charge the battery, simply insert the Gryphon into the
base. When the scanner is fully seated in the cradle, it will
sound a “chirp” to indicate that the cradle has detected
the scanner connection.
The LEDs on the base (shown in Table 1) will indicate the
status of the battery.
Battery Safety
To install, charge and/or do any other action on the bat-
tery, fo low the instructions in this manual.
Before using the Battery, read “Battery Safety”
in the following section. Datalogic recommends
annual replacement of rechargeable battery
packs to ensure maximum performance.
WARNING
Do not discharge the battery using any
device except for the scanner. When the bat-
tery is used in devices other than the desig-
nated product, it may damage the battery or
reduce its life expectancy. If the device
causes an abnormal current to flow, it may
cause the battery to become hot, explode or
ignite and cause serious injury.
Lithium-ion battery packs may get hot,
explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to
follow the safety warnings listed on the fol-
lowing page.