User Manual
Table Of Contents
- Gryphon™ I GBT4102
- Table of Contents
- Setting Up the Reader
- Configuring the Base Station
- Connecting the Base Station
- Charging the Batteries
- Linking the Reader
- Selecting the Interface Type
- Programming
- Stand Detection
- Technical Specifications
- LED and Beeper Indications
- Error Codes
- Base Station Indications
- Cleaning Procedure
- Datalogic Limited Factory Warranty
- Support Through the Website
- Ergonomic Recommendations
- Keypad
Connecting the Base Station
4Gryphon™ I GBT4102
Connecting the Base Station
Figure 1 shows how to connect the Base Station to a ter-
minal, PC or other host device. Turn off the host before
connection and consult the manual for that equipment (if
necessary) before proceeding. Connect the interface cable
before applying power to the Base Station.
Base Station Connection and Routing —
Fully insert the
Power Cable and Interface (I/F) Cable connectors into their
respective ports in the underside of the Base Station (see
Figure 1). Then connect to an AC Adapter, and plug the AC
power cord into the (wall) outlet.
Figure 1. Connecting the Base Station
Gryphon BT can also be Powered by the Ter-
minal. When powered by the Terminal, the
battery charger is automatically set as Slow
charge.
For some specific interfaces or hosts or
lengths of cable, the use of an external power
supply may be recommended for full recharg-
ing capability (see
"Technical Specifications"
on page 32
for more details)
Base
Station
I/F Cable
AC/DC
Adapter
DC Power
Cord
Wall plug
Connector