User manual

USE AND FUNCTIONING ________________________________________________________
6
Ed.: 06/00
44
The [FUNC]-[Y] sequence allows you to display the state
(STAT mode) of the keyboard by changing the cursor. By
pressing [FUNC]-[Y] again, it returns to the previous one.
The cursor will take on the appearance of the pixel matrix
of the font corresponding to the codes described in the
following table:
Also, if the battery level drops below a certain level, the
state of the keyboard will appear with its colors reversed.
This function depends greatly on the font chosen: if it
replaces one of the codes indicated, the cursor will take on
the appearance of the new pixel matrix.
BY pressing the [FUNC]-[X] keys, the cursor is replaced
with a BATT icon that represents the battery's charge state
or the
A
C
character that indicates the terminal has been
inserted into the cradle. The codes used are from 251 to
255. If the sequence [FUNC]-[X] is repeated, the system
returns to the previous cursor.
Since the cursor can only indicate one state or character at
a time, when more than one cursor indication is enabled
the priority from higher to lower is:
-Show the battery state
-Show the keyboard state
-Show the DOS cursor
STATE CODE CURSOR
ALPHA 0x41 A
NORMAL 0x4E N
FUNC
FUNC HOLD
0x46 F
FUNC SHIFT 0x66 f
SHIFT 0x53 S
STAT
[
Y
X
/