User manual

Ed.: 06/00
36
6
The use of the F7400 terminal is subordinate to the application software loaded,
whether it is provided by Datalogic, or created with the F7400 Development System.
Once an application is loaded, barcode scanning can be performed by pressing [SCAN].
6.1. TERMINAL START-UP
The F7400 terminal comes on when the batteries are inserted and goes in low
power consumption mode when it is no longer used for more than a
programmable time-out (usually 16 seconds).
It is possible to anticipate the low power consumption mode by pressing the key
sequence [SHIFT]-[SCAN].
To wake-up the F7400 terminal, press the [SCAN] key.
You can configure the F7400 terminal so that it comes on again automatically when:
- it receives some data from the com1 serial port;
- it receives something by RF;
- any key of the keyboard is pressed.
In the Devices sub-menu of SETUP, set the parameters “com1”, “ulSA” and
“Keyboard” to “Wakeup”.