User`s guide

DS6300 QUICK REFERENCE
17
The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a Class II laser
product according to CDRH regulations.
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to
hazardous laser light.
There is a safety device which allows the laser to be switched on only if the motor is rotating above the threshold
for its correct scanning speed.
The laser beam can be switched off through a software command (see also the Genius™ Help On-Line).
AVOID EXPOSURE - LASER LIGHT
IS EMITTED FROM THIS APERTURE
Laser Safety Label for Oscillating Mirror and Standard Models
CAUTION
LASER LIGHT
WHEN OPEN
AVOID EXPOSURE
TO BEAM
F
O
C
U
S
A
D
J
.
F
A
R
N
E
A
R
LASER LIGHT - DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
EN60825-1:1994
DATALOGIC S.P.A. Via Candini, 2
40012 LIPPO DI CALDERARA (BO) ITALY
MANUFACTURED VOLT
JANUARY 2002 10-30 DC
MODEL No.
SERIAL No.
This product conforms to the applicable requirements
of 21CFR 1040 at the date of manufacture.
N2468
Amp.
1.5-0.5
Warning and Device Class Label Device Identification Label
The laser diode used in this device is classified as a Class 3B laser product according to EN 60825-1 regulations
and as a Class IIIb laser product according to CDRH regulations. As it is not possible to apply a classification
label on the laser diode used in this device, the following label is reproduced below:
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAXIMUM OUTPUT RADIATION 35 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN60825-1 (1994)
Laser Diode Class Label
Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode
(35 mW at 630 ~ 680 nm).
Power Supply
- This product is intended to be installed by Qualified Personnel only.
-
All DS6300 Models:
This device is intended to be supplied by a UL Listed Power Unit marked “Class 2” or LPS power source
which supplies power directly to the scanner via the 25/26-pin connector.