System information

DS4800 OM QUICK GUIDE
22
COMPLIANCE
LASER SAFETY
The scanner is classified as a Class 2 laser product according to
EN 60825-1 regulations and as a Class II laser product according
to CDRH regulations.
Disconnect the power supply when opening the device during
maintenance or installation to avoid exposure to hazardous lase
r
light.
There is a safety device, which allows the laser to be switched on
only if the motor is rotating above the threshold for its correct
scanning speed.
The laser beam can be switched off through a software command
(see also the Genius Help On Line).
The laser diode used in this device is classified as a class 3B lase
r
product according to EN 60825-1 regulations and as a Class IIIb
laser product according to CDRH regulations.
Any violation of the optic parts in particular can cause radiation up
to the maximum level of the laser diode (40 mW at 630 to 680 nm).
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
CAUTION-CLASS 3B
LASER LIGHT WHEN OPEN
AVOID EXPOSURE TO BEAM
This product conforms to the
applicable requirements
of 21CFR1040 at the dat
e
of manufacture
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN 60825-1:2001
U.S. pat. 5,992,740; 6,394,352B1; 6,742,710B2; 6,688,524B1.
EP pat. 789,315B1; 959,426B9
DATALOGIC AUTOMATION S.r.l.
Via S. Vitalino, 13 – 40012 Calderara di Reno
MADE IN ITALY-
www.datalogic.com
Figure 13 - Warning and Device Class Labels
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of Datalogic could void the
authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or
LPS power source, which supplies power directly to the scanner via the 25-pin connector.
CE COMPLIANCE
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.