Installation manual

INTRODUCTION

2.1.1 Indicators

The five LEDs on the side of the scanner (Figure A

, 3) indicate the following:

LED Color Description

READY Green

This LED indicates the device is ready to operate. For Subzero

models this LED blinks during the warm-up phase.

GOOD Green

This LED confirms successful reading.

TRIGGER Yellow

This LED indicates the status of the reading phase. *

COM Yellow

This LED indicates active communication on main serial port. **

STATUS Red

This LED indicates a NO READ result.

* In On-Line mode the TRIGGER LED corresponds to the active reading phase signaled by the Presence Sensor.

In Automatic and Continuous modes the TRIGGER LED is always on indicating that the reader is ready to read a

code.

** When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in the

absence of data transmission, because of polling activity on the Fieldbus network.

During the reader startup (reset or restart phase), all the LEDs blink for one second.

On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner

is correctly powered.

2.2 ID-NET™

The ID-NET™ network is a built-in high-speed interface dedicated

for high-speed scanner interconnection. ID-NET™ is in addition to

the Main and Auxiliary serial interfaces.

The following network configurations are available:

 ID-NET™ M/S Synchronized: Single station – multiple scanners

CBX100

ID-NET™ interface allows local connection

of multiple scanners reading different sides

of the same target. All scanners share a

single presence sensor and

activate/deactivate simultaneously.

At the end of each reading phase a single

data message is transmitted to the host.

Thanks to ID-NET™, data communication

among scanners is highly efficient so tha

an immediate result will be available.