Installation manual

DS4800 REFERENCE MANUAL

STEP 6 – TEST MODE

NOTE

When entering the X-PRESS™ interface on the DS4800-X1XX the

Oscillating Mirror remains in the default fixed position (0°) in order to make

barcode reading easier while performing the X-PRESS™ functions.

Use a code suitable to your application to test the system. Alternatively, you can use the

Datalogic Test Chart (Code 128).

1. Enter the Test mode function by holding the X-PRESS™ push button pressed until the

TEST LED is on.

2. Release the button to enter the Test mode function.

Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts

reading barcodes the Bar-Graph shows the Good Read Rate. In case of no read

condition, only the STATUS LED is on and blinks.

green

yellow

red

READY

GOOD

TRIGGER

COM

STATUS

SETUP

LEARN

TEST

FOCUS

Figure 12 – X-PRESS™ Interface: Test Mode Function

3. To exit the Test Mode, press the X-PRESS™ push button once.

NOTE

By default, the Test Mode exits automatically after two minutes.