Installation manual

RAPID CONFIGURATION

1 RAPID CONFIGURATION

NOTE

This chapter illustrates a Stand Alone application. For other types of

installations, such as ID-NET™, Fieldbus, Pass-Through, Multiplexer

Layout, etc., refer to chapters 4, 5 and 6. For complete scanner

configuration using the Genius™ configuration program

, refer to the

Context-Sensitive Help On-Line.

STEP 1 – CONNECT THE SYSTEM

To connect the system in a Stand Alone configuration, you need the hardware indicated in

Figure 1.

In this layout the data is transmitted to the Host on the main serial interface.

In Local Echo communi

cation mode, the RS232 auxiliary interface can be used to transmit

data independently from the main interface selection.

When On-Line Operating mode is used, the scanner is activated by an External Trigger

(photoelectric sensor) when the object enters its reading zone.

Figure 1 – DS4800 in Stand Alone Layout

Figure 2 – DS4800 OM in Stand Alone Layout

DS4800

Host

PG 6000

P.S.*

* Presence Sensor

(for On-Line mode)

CBX100/500

I/O, AUX

MAIN

DS4800 OM