User's Manual

Battery Installation
To install the battery pack, follow the steps below:
1. Rotate the latches to the open position. Grab the battery cover by
the sides and lift it out of the way:
2. Remove the battery pack from the battery box
1
. Insert the
battery pack into the slot, top (contacts) side first, and press it
into place:
3. Insert the battery cover, bottom first, and press it into place.
Rotate the latches to the lock position to lock the cover:
4. Press and release the power button to turn the DL-Axist on.
1. Always use the battery box to carry the battery pack. Do not
put the battery pack in your pocket.
Charging Instructions
The battery pack is not initially fully charged. After installing the bat-
tery, charge it with the USB cable or with the single dock.
Charge with USB
You can use the provided USB charge/communication cable in
conjunction with the power supply adapter (p/n 94ACC0135) to charge
the terminal from a power outlet.
Charge with the Dock
NOTE
Charge the battery for a minumum of 4 hours for the standard
battery and 8 hours for the extended battery.
NOTE
Use only a Datalogic approved power supply.
Scanning and Imaging
Imager Data Capture
To scan a barcode symbol:
1. Point the scan window at the barcode.
2. Tap Scan on the screen or press one of the scan buttons on the
DL-Axist. The imager projects a laser aiming pattern similar to
those used on cameras. The aiming pattern is used to position
the barcode or object within the field of view.
3. Center the symbol in any orientation within the aiming pattern.
Ensure the entire symbol is within the rectangular area formed by
the brackets in the aiming pattern, then either wait for the
timeout or release the scan key to capture the image. A red beam
illuminates the symbol, which is captured and decoded.
Aiming System Pattern
If the scan has been successful:
• If enabled, the good read LED glows steadily green for a
configurable time.
• If enabled, the good read beep plays.
• The barcode type and content data display on the screen.
Linear Bar Code
2D Matrix Symbol
SD Card / SIM Card Installation
1. Turn off the DL-Axist or put it in swap battery mode (refer to the
User's Manual for more details).
2. Remove the battery cover (see
Battery Installation, step 1)
3. Remove the battery pack by pulling the tab on the bottom of the
battery. Lift the retaining door:
4. Slide the microSD card/SIM card holder to the left to unlock it.
5. Lift the holder:
6. Insert the microSD card/SIM card into the holder. Make sure the
contacts side is face down.
7. Close the holder and shift it to the right to lock it:
8. Close the retaining door.
9. Insert the battery pack into the slot.
10. Insert the battery cover (see
Battery Installation, step 3).
SIM Card
MicroSd Card
SIM Card
MicroSD Card
MicroSD Card
SIM Card
MicroSD Card
SIM Card
DRAFT VERSION
DRAFT VERSION
DRAFT VERSION