User manual

Enter/Exit Programming Mode

Gryphon™ I GD44XX

GBT4400

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good

read. The good read LED on time can be set within a range of 10 milliseconds to 2,550

milliseconds (0.001 to 2.55 seconds) in 100ms increments. A setting of 00 keeps the LED on

until the next trigger pull.

See page 270 in “References” for detailed instructions and examples for setting this feature.

$CLAGL00(CR)

Good Read LED Duration Setting =

Keep LED on until next trigger pull

$CLAGL

Select Good Read LED Duration Setting

To configure this feature, scan

the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

lef

t followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

bar

code again.

Make a mistake? Scan the CANCEL bar code to abort

and not sav

e the entry string. You can then start again at

the beginning.

CANCEL

DEFAULT

020 = Good Read LED

stays on for 2 seconds.

Indicators are dimmed during sleep.