User manual

Enter/Exit Programming Mode
Product Reference Guide 57
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks keyboard
connection in order to transmit data to host. The selectable range for this setting is 00 to 990
milliseconds (00-0x63 by 01) in increments of ten milliseconds.
See page 256 in “References”
for detailed information and examples for setting this feat
ure.
$CKBQI
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGR
AMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barc
ode again.
Make a mistake? Scan the C
AN
CEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
0A = Quiet Interval is
100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
See page 258 in “References” for detailed information and examples for setting this feature.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barc
ode again.
Make a mistake? Scan the CANCEL barcode to
abort an
d not save the entry string. You can then
start again at the beginning.
~
CANCEL