User manual

Enter/Exit Programming Mode

Product Reference Guide

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the host

following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15

seconds) in 200ms increments. A selection of 0 disables the timeout.

See page 252 for more information on setting this feat

ure.

$CR2AT

Select ACK NAK Timeout Value Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE barcode above, then the

barcode at left followed by the digits from the

Alphanumeric characters in Appendix D, Keypad

representing your desired character(s). End by

scanning the ENTER/EXIT barc

ode again.

Make a mistake? Scan the CANCEL bar code to

abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

01 ACK NAK Timeout value is 200ms

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry

condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and

a selection of 255 specifies unlimited retries. See page 253 for more information.

$CR2AR

Select ACK NAK Retry Count Setting