User manual

Enter/Exit Programming Mode

Product Reference Guide

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

See page 257 for more information.

$CR2IC00(CR)

Intercharacter Delay = No Delay

$CR2IC

Select Intercharacter Delay Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE barcode above, then the

barcode at left followed by the digits from the

Alphanumeric characters in Appendix D, Keypad

representing your desired character(s). End by

scanning the ENTER/EXIT barc

ode again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start again at

the beginning.

CANCEL

DEFAULT

00 = No Intercharacter Delay