User manual

288 Gryphon™ I GD44XX / GBT4400
Table 51
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program-
ming Mode Entry
A valid programming label has
been scanned.
LED blinks continuously
Reader sounds four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of Label
A la
bel has been rejected.
N/A
Reader sounds three times at
lowest frequency & current vol-
ume.
Label Program-
ming Mode
A
ccep
tance of
Partial Label
In cases where multiple labels
must be scanned to
program one
feature, this indication acknowl-
edges each portion as it is suc-
cessfully scanned.
N/A
Reader sounds one short beep
at highest fre
quency & current
volume.
Label Program-
ming Mode
Accep
tance of
Programming
Configuration option(s) have
been successfully progr
ammed
via labels and the reader has
exited Programming Mode.
N/A
Reader sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by reset
beeps
.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned.
N/A
Reader sounds two times at low
frequency and current volume.
. Programming Mode Indications
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its
automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is
reset, the sequence will be repeated. The following table describes the LED flashes/beep codes
associated with an error found.
NUMBER OF
LED FLASHES/
BEE
PS
Model GD44XX
ERROR
Model GBT4400
ERROR
CO
RRECTIVE ACTION
1 Configuration Configuration
Contact Helpdesk for assis-
tance
2 Interface PCB Interface PCB
6 Digital PCB Digital PCB
11 Imager N/A
12 N/A Imager
15 N/A Accelerometer