User manual

References
280 Gryphon™ I GD44XX / GBT4400
BT-Only Features
BT Pin Code
This option specifies the 4-character or 16-character pin code to be used for authentication of
the BT link. To set the pin code:
1. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode, then enable "BT S
ecurity Mode" on page 241.
2. Specify the desired pin code length (4 or 16) by scanning the appropriate bar
code in
"Select PIN Code Length" on page 242.
3. Determine the desired characters. F
or example, D254 or STOR12345678135M
4. Convert the characters to hexadecimal using the ASCII Chart on the inside back cover of
this manual.
5. Go to page 242 and Scan the bar code: SET 4 CHAR PIN CODE or SET 16-CHAR
PIN CODE.
6. Scan the appropriate alphanumeric characters from the keypad in Ap
pendix D, Keypad,
representing the hexadecimal entries determined in the steps above. You will hear a two-
beep indication after the last character
.
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry string. You can then start again at the beginning.
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
Changing the pin code setting will unlink the devices. If the Automatic Configu-
ration Update is set to the default enabled setting, the devices must only be
relink
ed. If the Automatic Configuration Update is set to the disabled setting,
the Pin Code setting must also be updated in the Base Station using Aladdin.
After the Base Station has been updated, the devices must be relinked.
Table 47. BT Pin Code Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting D254 STOR12345678135M
2
Convert the characters to
hexadecimal
44 32 35 34 53 54 4F 52 31 32 33 34 35 36 37 38 39 31 33 35 4D
3 Scan ENTER/EXIT PR
OGRAMMING MODE
4 Scan SET BT PIN CODE
5
Scan 8 or 32 Alphanumeric
Character
s From
Appendix
D, Keypad
31323334 53544F523132333435363738393133354D
6 Scan ENTER/EXIT PROGRAMMING MODE