User manual

Enter/Exit Programming Mode
240 Gryphon™ I GD44XX / GBT4400
Link Timeout
This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See page 252 for more information on setting this feat
ure.
$CBTLT
Set Link Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CAN
CEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
02 Link Timeout value is 2 seconds