User manual

QR Code Enter/Exit Programming Mode
Product Reference Guide 219
QR Code Length Control
This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CQRLC00(CR)
QR Code Length Control = Variable Length
$CQRLC01(CR)
QR Code Length Control = Fixed Length
QR Code Set Length 1
Specifies one of the bar code lengths for QR Code Length Control. Length 1 is the minimum
label length if in Variab
le Length Mode, or the first fixed length if in Fixed Length Mode.
Characters can be set from 0001 to 7,089 characters in increments of 0001 (pad with zeroes).
See page 259 for detailed instructions on setting this feature.
$CQRL1
Select QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
lef
t followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
barc
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not sav
e the entry string. You can then start again at
the beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character