User manual

Product Reference Guide 105
1D SYMBOLOGIES
1D Code Selection
The reader supports the following 1D symbologies (bar code types). See "2D Symbologies"
starting on page 197
for 2D bar codes. Symbology-dependent options are included in each
chapter.
• Disable All Symbologies, page 106 • GS1-128, page 144
• Code EAN/UPC, page 107 • Code ISBT 128, page 145
• UPC-E, page 110 • Interleaved 2 of 5 (I 2 of 5), page 148
• GTIN Formatting, page 113 • Interleaved 2 of 5 CIP HR, page 153
• EAN 13 (Jan 13), page 114 • Follett 2 of 5, page 153
• ISSN, page 116 • Standard 2 of 5, page 154
• EAN 8 (Jan 8), page 117 • Industrial 2 of 5, page 158
• UPC/EAN Global Settings, page 119 • Code IATA, page 162
• Add-Ons, page 121 • Codabar, page 163
• Code 39, page 128 • ABC Codabar, page 169
• Trioptic Code, page 134 • Code 11, page 172
• Code 32 (Ital Pharmaceutical Code),
page 134 • GS1
DataBar™ Omnidirectional, page 176
• Code 39 CIP (French Pharmaceutical), page 136 • GS1 D
ataBar™ Expanded, page 177
• Code 39 Danish PPT, page 136 • GS1 DataBar™ Limited, page 182
• Code 39 LaPoste, page 137 • Code 93, page 183
• Code 39 PZN, page 137 • MSI, page 188
• Code 128, page 138 • Plessey, page 193
Default settings are indicated at each feature/option w
ith a green arrow. Also reference
Appendix B, Standard Defaults for a listing of the most widely used set of standard factory
settings. That section also provides spac
e to record any custom settings needed or implemented
for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable pr
ogram-
ming pages.
2. Scan the correct bar code to set the desired programming feature or parameter. You may
need to cove
r unused bar codes on the page, and possibly the facing page, to ensure that
the reader reads only the bar code you intend to scan.
3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the
appropriate characters from the keypad.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to
ab
ort and not save the entry string. You can then start again at the
beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING bar code to exit Programming Mode.