Quick Start Guide

Power the Dock
1. Plug in the cigarette lighter adapter
1
into your vehicle’s cigarette
lighter.
2. Insert the cigarette lighter adapter output plug in the dock power jack
(see figure below). When the dock is powered, the Power ON LED lights
up solid green.
Make sure your vehicle’s power source is between 10 to 30 VDC,
and is capable of supporting a 4000mA current drain. If you
have any concerns regarding this, refer to your vehicle owner’s
manual.
CAUTION
The cigarette lighter adapter must not be used if the battery car
is fully depleted.
CAUTION
To reduce quiescent current and extend battery life, disconnect
the dock when the car is not powered.
NOTE
1 Available as accessory:
y 94A050045 POWER ADAPTER 12/24VDC CLA, MEMOR 10 (U.S. Models)
y 94A050048 POWER ADAPTER,12/24VDC CLA, MEMOR 10 (E.U. Models)
Charge the Memor 10
To insert the Memor 10 into the dock, the rubber boot is needed.
The rubber boot provides additional protection to the device and is
available as optional accessory (P/N 94ACC0193 for; standard models; P/N
94ACC0204 for healthcare models).
Insert the Memor 10 with the rubber boot into the dock with the screen
facing front and the head facing up.
Make sure there is nothing between the dock and the device.
Do not put any foreign object such as, but not limited to, coins,
paper clips, stickers inside the slot of any of the docks.
Do not apply any sticker to the Memor 10 (see the examples
below).
CAUTION
Do not attempt to charge any other device different from the
Memor 10 devices.
WARNING
Do not use the Memor 10 while driving. The user is responsible
for driving safely.
CAUTION
LED Indicators
LED Behavior Operation Status
Power ON
Solid green Dock is powered
Foreign Object Detection (FOD)
Blinks red slow at 0.625Hz Foreign object detected, output power is
reduced.
Blinks red fast at 2.5Hz Foreign object detected, output power is further
reduced.
Solid red Foreign object detected, output power is
disabled.
In case of FOD led blinking, remove the foreign object.
CAUTION
Technical Specifications
Electrical Features
Power Supply (with CLA) From 10 to 30 VDC
Indicators Consumption Power on LED (green)
FOD LED (red)
Environmental Features
Working Temperature 0°C to 40°C
Storage Temperature -30°C to 70°C
Humidity 5-95% non-condensing
Vibration Resistance EN60068-2-64
Shock Resistance EN60068-2-27
Mechanical Features
Dimensions 202 x 89 x 61 mm / 7.9 x 3.5 x 2.4 in
Weight 269 g / 9.48 oz
335 g / 11.82 oz (with cigarette lighter power
adapter)