User`s manual

DL TCL™ EXTENDED COMMANDS

The management of this feature depends on the selection of the Multi-Session

parameter:

- Single Session: the Multi-Session parameter is set to off and the terminal tries

to connect to the first KC PC available. First, it tries to connect

to KC HOST 1 and, if not available, to KC HOST 2..4. In case

of failure, the terminal will try to connect to the Host PC by

entering automatically the Direct Host Mode (see par. 1.1.1

for details). If even the Host PC cannot be found, the terminal

displays the opening mask allowing to start the configuration

or configuration again.

Once a KC PC is found, the terminal enters Mode 1 (only one

session is allowed) and starts working within the desired

application running on the remote Host the KC PC is

connected to.

By pressing the [ALT][0] keys in sequence the program

returns to the Applications mask allowing to change the

session the terminal is connected to. The current session is

signaled in reverse video within the list. Once a new session

is set, the current one is automatically disabled and the

terminal starts emulating a new application/application

session. If no change has been made, press [Enter] to return

to the current session.

- Multiple Session: the Multi-Session option is set to on. The terminal works as in

Single Session but in this case it can manage up to 4 different

sessions (Mode 1, Mode2, Mode 3 and Mode 4) at the same

time. It is possible to switch from one application to another by

pressing the following keys in sequence:

[ALT][1] = Mode 1

[ALT][2] = Mode 2

[ALT][3] = Mode 3

[ALT][4] = Mode 4

By pressing [ALT][0] in sequence the program returns to the

Applications mask as in Single Session. In this case, the

selection of a new session causes the closure of the

substituted one while the other sessions remain active.

For Viper™ 48-Key Models and Rhino™

the key sequence

switching from one application to another is the following:

[ALT][B] = Mode 1

[ALT][C] = Mode 2

[ALT][D] = Mode 3

[ALT][E] = Mode 4

[ALT][A] = Returns to Application Mask as in Single Mode