User`s manual

DL TCL™

4.2.1 TCP/IP

If selecting this submenu, the following masks appear allowing to define the IP

parameters related to the terminal.

"1"

[ENTER]

Datalogic - SETUP

Network Settings

1) TCP/IP

2) Radio

3) Connection

ENTER to Continue

Datalogic - SETUP

Network TCP/IP 1/2

1) IP Address

2) Subnet Mask

3) Gateway Address

ENTER to Continue

Datalogic - SETUP

Network TCP/IP 2/2

4) DNS Address

5) Device Name

ENTER to Continue

Figure 34 - TCP/IP Diagram

 IP Address

The IP Address may be defined either manually (static), through DHCP (Dynamic

Host Configuration Protocol) or through BOOTP (Bootstrap Loader):

Datalogic - SETUP

Network IP Address

1) Static

2) Enable DHCP

3) Enable BOOTP

ENTER to Continue

Figure 35 - ID Address Selection

When defining the address manually (Static selection), the following mask appears:

Datalogic - SETUP

Network IP Address

- Static IP Address:

ENTER to Continue

Figure 36 – Defining Static IP Address