User`s manual

DL TCL™
14
3
Clear Before Scan
This special key is only available in connection with an AS400 host. If checked, it
clears the input field before sending the barcode read.
Baud Rate (available only for Rhino™)
This parameter is available only when the Rhino™ Barcode Input parameter is set to
Scanner (COM2/Scanner), Cordless-Card or Serial (COM1). Refer to DL Mobile
Configurator™ Enterprise 2 User’s Manual for further details.
It defines the baud rate.
Parity (available only for Rhino™)
This parameter is available only when the Rhino™ Barcode Input parameter is set to
Scanner (COM2/Scanner), Cordless-Card or Serial (COM1). Refer to DL Mobile
Configurator™ Enterprise 2 User’s Manual for further details.
It indicates the presence of a control bit in the communication protocol frame.
Data Bits (available only for Rhino™)
This parameter is available only when the Rhino™ Barcode Input parameter is set to
Scanner (COM2/Scanner), Cordless-Card or Serial (COM1). Refer to DL Mobile
Configurator™ Enterprise 2 User’s Manual for further details.
It indicates the number of bits composing the data packet of the communication
protocol frame.
Stop Bits (available only for Rhino™)
This parameter is available only when the Rhino™ Barcode Input parameter is set to
Scanner (COM2/Scanner), Cordless-Card or Serial (COM1). Refer to DL Mobile
Configurator™ Enterprise 2 User’s Manual for further details.
It indicates the number of stop bits the data packet of the communication protocol
frame.
3.6.1 Barcode Formatting
The Barcode Formatting area allows either selecting the codes to be read through an
input filtering mask or defining the output format of the code to be transmitted,
including possible code division into fields.