User Manual

Reading Parameters Enter/Exit Programming Mode

Product Reference Guide

Select Audio Jingle for Exit Base Station

This parameter selects which preloaded Jingle to use in indicating an Exit Base

Station event.

NOTE

"Audio Jingle Enable"

on page 83 must be selected for this configuration

item to take effect.

After uploading up to fifteen (15) Jingles to the scanner using the Datalogic

Aladdin

™

configuration utility, use this setting to designate which of the Jingles

(1-15) will be sounded when the scanner exits Base Station.

Select Audio Jingle on Exit Stand Mode

To configure this feature, scan the ENTER/EXIT barcode

above, then the barcode at left followed by two digits

from the Alphanumeric characters in

Appendix D,

Keypad

representing the desired Jingle #. End by scan-

ning the ENTER/EXIT barcode again.

Make a mistake? Scan the CANCEL barcode to abort and

not save

the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

00 = Use built-in Exit Base Station indication

NOTE

The capability to download Audio jingle require Datalogic Aladdin™ configu-

ration software, for this reason it is possible

only if the reader is used with

the base station.

$CAUXM