User Manual

Enter/Exit Programming Mode Audio Jingles
86 RIDA™ DBT6400
Select Audio Jingle for Enter Base Station
This parameter selects which preloaded Jingle to use in indicating an Enter Base
Station event.
NOTE
"Audio Jingle Enable" on page 83 must be selected for this configuration
item to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
™
configuration utility, use this setting to designate which of the Jingles
(1-15) will be sounded when the scanner enters Base Station.
Select Audio Jingle on Enter Stand Mode
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = Use built-in Enter Base Station indication
NOTE
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible
only if the reader is used with
the base station.
$CAUEM
~