User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 85
Select Audio Jingle for Good Read Event
This parameter selects which preloaded Jingle to use in indicating a good read
event.
NOTE
"Audio Jingle Enable" on page 83 must be selected for this configuration
item to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
™
configuration utility, use this setting to designate which of the Jingles
(1-15) will be sounded when the scanner performs a good read.
Select Audio Jingle on Good Read
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = Use built-in Good Read Jingle (Shutter.wav)
NOTE
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible
only if the reader is used with
the base station.
$CAUGR
~