User Manual

Enter/Exit Programming Mode Label ID
72 RIDA™ DBT6400
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To set,
first define whether you want it as a prefix or suffix by scanning a label below.
Then turn to Label ID Symbology Selection − 1
D Symbologies, starting on page
73 to select the symbology you want to set, followed by up to 3 characters from
the ASCII Chart at the back
of this manual. See "Label ID: Set Individually Per
Symbology" on page 240 for detailed instructions on setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or suffix
for a given symbology type.
DEFAULT
$CIDCO00(CR)
Label ID Transmission = Disable
$CIDCO01(CR)
Label ID Transmission = Enable as Prefix
$CIDCO02(CR)
Label ID Transmission = Enable as Suffix