User Manual

Enter/Exit Programming Mode Intercode Delay
62 RIDA™ DBT6400
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds. See "Intercode Delay"
on page 234 for more detailed programming in
structions.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired char
acter(s). End by scanning
the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = No Wedge Intercode Delay
$CKBID
~