User Manual

Keyboard Interface Enter/Exit Programming Mode
Product Reference Guide 61
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. This parameter is only valid for USB Key-
board (without alternate key encoding) inte
rface on the base station. The delay
can be set within a range of zero (0) to 990 milliseconds in 10ms increments. A
setting of zero specifies no delay. See "Intercharacter Delay" on
page 233 for
more detailed progr
amming instructions.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired char
acter(s). End by scanning
the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
00 = No Intercharacter Delay
$CR21C00
$CR21C
~