User Manual

Enter/Exit Programming Mode

22 RIDA™ DBT6400

To program features:

1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each

programming page, when applicable.

2. Scan the barcode to set the desired progr

amming feature. You may need

to cover unused barcodes on the page, and possibly the facing page, to

ensure that the scanner reads only the barcode you intend to scan.

3. If additional input parameters ar

e needed, go to

Appendix D, Keypad

, and

scan the appropriate characters from the keypad.

NOTE

Additional information about many features can be found in the “Ref-

erences” chapter.

If you make a mistake before the last character, scan the CANCEL bar-

code to abort and not save the entry string. You can then start again at

e beginning.

4. Complete the programming sequence by scanning the ENTER/EXIT PRO-

GRAMMING barcode to exit Programming Mode.

For more detailed descriptions, programming information an

d examples for

setting selected configuration items, see

References, starting on page 235