User Manual

Data Format
Product Reference Guide 241
Label ID: Set Individually Per Symbology — continued
Table 12
STEP ACTION EXAMPLES
1.
Scan the ENTER/EXIT
barcode
(Scanner enters Programming Mode)
2.
Determine placement of the
Label ID characters BEFORE
or AFTER w
ith regard to
scanned data using
"Label
ID Control"
on page 71
Enable as Prefix Enable as Suffix Enable as Prefix Enable as Suffix
3.
Scan the barcode selecting
the symbology type you
wish to designate label ID
characters for using
Case
Conversion, starting on page
78
.
GS1 DataBar
Omnidirectional
Code 39 Interleaved 2 of 5 Code 32
4.
Custom Label ID example
(desired characters):
D B * = C 3 + P H
5.
Find hex equivalents from
the ASCII table (inside
back
cover), then scan in these
digits/characters using the
barcodes in the section:
Keypad, starting on page
295
. f you make a mistake
before the last character,
scan the CANCEL barcode to
abort and not save the entry
string. You can then start
again at the beginning.
44 42 2A 3D 43 33 2B 50 48
6.
Scan the ENTER/EXIT
barcode
(Scanner exits Label ID entry)
7.
Scan the ENTER/EXIT
barcode once
again
(Scanner exits Programming Mode)
Result:
DB*[barcode
data]
[barcode
data]=C3
+[barcode data] [barcode data]PH
. Label ID Examples