User Manual

Enter/Exit Programming Mode Code 93

186 RIDA™ DBT6400

Code 93 Set Length 2

This feature specifies one of the barcode lengths for Code 93 Length Control on

page 184. Length 2 is the maximum label length if in Variable Length on page

184 Mode, or the second fixed length if in Fixed Length on page 184 Mode.

Length includes the barcode’s check, data

, and full-ASCII shift characters. The

length does not include start/stop characters.

The length can be set from 1 to 50 characters. A setting of 00 specifies to

nore this length (only one fixed length). See "Set Length 2" on

page 249 for

more detailed programming instructions.

Select Code 93 Length 2 Setting

To configure this feature, scan the ENTER/EXIT barcode

above, then the barcode at left followed by digits from

the Alphanumeric characters in

Appendix D, Key-

pad

representing your desired character(s). End by

scanning the ENTER/EXIT barcode again.

Make a mistake? Scan the CANCEL barcode to abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

50 = Length 2 is 50 Characters

$CC9L2