User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 99
RGB Good Read Falling Time
Specifies the time for the RGB good read to change the status from the Bright-
ness state to the Off state.
See
"RGB Good Read Raising/Falling Time" on page 243 for more detailed program-
ming instructions.
Set RGB Good Read Falling Time
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the EN
TER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
14 = 2 seconds Falling Time
$CRBFT
~