Manualshelf

User Manual

ManualsBrandsDatalogic ManualsBarcode ScannersBarcode Scanner 1D Linear Code/2D Code 0 ... 400 mm
101102103104105106107108109110
Enter/Exit Programming Mode RGB LED Settings
98 RIDA™ DBT6400
RGB Good Read Raising Time
Specifies the time it will take for the RGB good read to change the status from
an Off state to Brightness state.
See
"RGB Good Read Raising/Falling Time"
on page 243 for more detailed program-
ming instructions.
Set RGB Good Read Raising Time
To configure this feature, scan the ENTER/EXIT barcode
above, then the barcode at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = No time
$CRBRT
~