Installation manual

MAINTENANCE AND TROUBLESHOOTING
37
5
5.3.2 DS8100A/DX8200A Troubleshooting
Figure 28 - 8K Scanner Display and Keypad
PROBLEM
SUGGESTION
Power On failure: “Power On”
LED is OFF
Check power connection
Encoder Failure: The
“Encoder LED” is off when the
encoder signal is present
Check cabling
Communication Failure: the
scanner “Network” LED is
OFF.
Check the connections with the SC6000. If the error
persists, contact your Datalogic distributor.
Low Read Rate:
Check the reading performance: from Genius™: run
SPY and put the reader in “Test Mode”.
Check PackTrack and Mirror Calibration (see
following paragraph).
Check PS Offset (DX8200A only)
5.4 MIRROR CALIBRATION AND TEST
On the SPY Menu Bar select Tools and Mirror Calibration to obtain the following window:
Place a code under a beam at a distance of 1 meter.