Installation manual

BHS AND REDS INSTALLATION MANUAL
8
2
2.2.4 DX8200A Reference Point Stops
One pair of washers and one pair of spacers (reference point stops) are provided with the
DX8200A. They are intended to be mounted to the Reading Station Frame using Bosch T-
bolts and nuts to create 2 stops which can be used to facilitate DX8200A mounting,
positioning and replacing.
Figure 7 - Reference Point Stops
2.2.5 Alternative Encoder Mounting
When used, the encoder is normally mounted to Profile #7 in Figure 3. The Standard BHS
Mounting Frame also contains profiles for alternative encoder mounting to the conveyor
frame.
The numbers in the figure below refer to the pieces of the Standard BHS Mounting Frame
shown in Figure 3. Profile #15 is mounted directly under the conveyor border to appropriate
holes on the conveyor frame (located 10 cm apart). Depending on the conveyor frame hole
positioning, the angular brackets at the ends of the bar may or may not be necessary for
mounting.
Figure 8 - Alternative Encoder Mounting