Installation manual

DS2100N REFERENCE MANUAL
7
SOFTWARE FEATURES
READABLE CODES
* EAN/UPC (including Add-on 2 and Add-on 5) * Code 93
* 2/5 Interleaved * Code 128
* Code 39 (Standard and Full ASCII) * EAN 128
* Codabar ISBT 128
*ABC Codabar Pharmacode
*ACB Readable. Other symbologies available on request.
Code Selection
up to ten different symbologies during one reading phase
Decoding Safety
can enable multiple good reads of same code
Headers and Terminators
Up to 128-byte header string
Up to 128-byte terminator string
Operating Modes
On-Line, Serial On-Line, Verifier,
Automatic, Continuous, Test
Configuration Modes
Genius™ utility program
Genius™ based Host Mode Programming
X-PRESS™ Functions
Special Functions
Code Verifier
ACB (Advanced Code Builder)
Motor Off and SW_Speed Control
Programmable Diagnostic and Statistic Messages
Parameter Storage
Non-volatile internal Flash
ENVIRONMENTAL FEATURES
Operating Temperature (Note 3)
0° to +45
°C (+32° to +113 °F)
Storage Temperature
-20° to +70
°C (-4° to +158 °F)
Humidity max. 90% non condensing
Vibration Resistance EN 60068-2-6
14 mm @ 2 to 10 Hz; 1.5 mm @ 13 to 55 Hz;
2 g @ 70 to 200 Hz; 2 hours on each axis
Bump Resistance EN 60068-2-29
30g; 6 ms; 5000 shocks on each axis
Shock Resistance EN 60068-2-27
30g; 11 ms; 3 shocks on each axis
Protection Class IP65
PHYSICAL FEATURES
Mechanical Dimensions 68 x 84 x 34 mm (2.68 x 3.31 x 1.34 in)
Weight 330 g (11.6 oz)
Note 1: The features given are typical at a 25
°C ambient temperature (if not otherwise indicated).
Note 2: Further details given in par. 3.3.
Note 3: If the reader is used in high temperature environments (over 35
°C), use of the Beam Shutter is advised (see the
Genius™ configuration program).
64