Installation manual

Disconnect the power supply when opening
the device during maintenance or installation
to avoid exposure to hazardous laser light.
The laser diode used in this device is
classified as a class 3B laser product
according to EN 60825-1 regulations and as a
Class IIIb laser product according to CDRH
regulations.
Any violation of the optic parts in particular
can cause radiation up to the maximum level
of the laser diode (35 mW at 630 to 680 nm).
AVOID EXPOSURE LASER LIGHT
IS EMITTED FROM THIS APERTURE
CAUTION-CLASS 3B LASER LIGHT
WHEN OPEN AVOID EXPOSURE TO BEAM
This product conforms to the
applicable requirements
of 21CFR1040 at the
date of manufacture
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN 60825-1:2001
Pat. US5992740, EP0789315B1
DATALOGIC AUTOMATION Srl
Via S. Vitalino, 13 – 40012 Calderara di Reno
MADE IN ITALY-
www.datalogic.com
Warning and Device Class Labels
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit
with «Class 2» or LPS power source, which supplies power directly to the scanner via the 25-
pin connector.
CE COMPLIANCE
Warning:
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WEEE COMPLIANCE
ENGLISH
Information for the user in accordance with the European Commission Directive 2002/96/EC
At the end of its useful life, the product marked with the crossed out wheeled wastebin must be disposed of
separately from urban waste.
Disposing of the product according to this Directive:
• avoids potentially negative consequences to the environment and human health which otherwise could
be caused by incorrect disposal
• enables the recovery of materials to obtain a significant savings of energy and resources.
For more detailed information about disposal, contact the supplier that provided you with the product in question
or consult the dedicated section at the website www.automation.datalogic.com.
vii