Installation manual

DS2100N REFERENCE MANUAL
2
2.3.2 X-PRESS™ Functions
Quick access to the following functions is provided by
an easy procedure using the push button:
1 – Press the button (the F0 LED will give a visual
feedback).
2 – Hold the button until the specific function LED is
on (F1, F2 or F3).
3 – Release the button to enter the specific function.
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
Once button is pressed, the cycle of LEDs activation is as follows:
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS

Release button to
Exit

Release button to
enter Test Mode

Release button to
enter AutoLearn
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS

Release button to
enter AutoSetup
 (cycle)
Release button to
Exit
Test Mode (F1) Function
Once entered, the Bar Graph on the five LEDs is activated and if the scanner starts reading
barcodes the Bar-Graph shows the Good Read Rate. In case of no read condition, only the
STATUS LED is on and blinks.
To exit the Test Mode, press the X-PRESS™ push button once.
18