Installation manual

RAPID CONFIGURATION
1
Auto Learn
If you are configuring your scanner using X-PRESS™, you must start with the Auto Learn
procedure.
1. Enter the Auto Learn function (F2) by pressing the X-PRESS™ push button.
2. Hold the push button pressed until the F2 LED is on.
3. Release the button to enter the Auto Learn function.
Once entered, the reader starts a procedure to automatically detect and recognize
barcodes (by type and length), which are presented to it (*). The laser turns on and the
TRIGGER LED blinks to indicate the ongoing process.
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
A
utoSetup
A
utoLearn
Test Mode
Exit
Figure 5 – X-PRESS™ Interface: Auto Learn Function
The procedure is as follows:
A) place the desired barcode on the
scanline.
B) wait until the TRIGGER LED
stays steady on (indicating the
reader has detected the barcode).
C) repeat, if needed, the above two
steps to program up to 10
different barcodes (either by
length or by symbology). If more
than one barcode is detected, the
Multi Label mode is enabled (refer
to the “2000 Family Software
Configuration Parameter Guide”
Help file).
4. Exit the process by pressing the X-PRESS™ push button once. The scanner will restart
at the end of the process, and then the detected barcodes are automatically configured in
scanner memory.
NOTE
If the barcode cannot be read because of low contrast or excessive ambient
light, you can perform the AutoSetup function to optimize the optical
parameters. Then you can perform AutoLearn to recognize the barcode
symbology.
5