Installation manual

DS2100N REFERENCE MANUAL
1
STEP 3 – X-PRESS™ CONFIGURATION
X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of
installation and maintenance.
Status and diagnostic information are clearly presented by means of the five colored LEDs,
whereas the single push button gives immediate access to the following relevant functions:
• Test Mode (F1) with bar graph visualization to check
static reading performance
• AutoLearn (F2) to self-detect and auto-configure for
reading unknown barcodes (by type and length)
• AutoSetup (F3) to self-optimize and auto-configure
reading performance in demanding applications
NOTE
If using the OM2000N accessory, when entering the X-PRESS™ interface, the
Oscillating Mirror remains in the default fixed position (-15°) in order to make
barcode reading easier while performing the X-PRESS™ functions.
The colors and meaning of the five LEDs are illustrated in the following table:
F4
READY (green) This LED indicates the device is ready to operate.
F3
GOOD (green) This LED confirms successful reading.
F2
TRIGGER (yellow) This LED indicates the status of the reading phase.
F1
COM (yellow) This LED indicates active communication on main serial port.
F0
STATUS (red) This LED indicates a NO READ result.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner
is correctly powered.
4