Installation manual

DS2100N REFERENCE MANUAL

C-BOX 100/150 Pinout for DS2100N

The table below gives the pinout of the C-BOX 100/150 terminal block connectors. Use this

pinout when the DS2100N reader is connected by means of the C-BOX 100/150:

C-BOX 100/150 Terminal Block Connectors

Power Outputs

1, 3, 5 VS 21 OUT 1+

2, 4, 6 GND 22 OUT 1-

7, 8 EARTH GROUND 23 OUT 2+

20, 40 Reserved 24 OUT 2-

Inputs

25 NC

27 EXT TRIG A (polarity insensitive) 26 NC

28 EXT TRIG B (polarity insensitive)

Auxiliary Interface

29 NC 35 TX AUX

30 IN2- 37 RX AUX

31, 33 NC

ID-NET™

32, 34 NC 36 ID-NET-

39 GND 38 ID-NET+

Main Interface

RS232

RS485 Full-

Duplex

RS485 Half-Duplex

20 mA C.L.

(with

INT-30 only)

11, 15 TX 232 TX 485+ RTX 485+

12, 16 RTS 232 TX 485- RTX 485-

17 RX 232 *RX 485+

18 CTS 232 *RX 485-

10, 14,

SGND SGND SGND

9, 13

RS485 Cable

Shield

RS485 Cable Shield

see INT-30

instructions

* Do not leave floating, see par. "RS485 Full-Duplex Interface" for connection details.

CAUTION

Do not connect GND and SGND to different (external) ground references.

GND and SGND are internally connected through filtering circuitry which

can be permanently damaged if subjected to voltage drops over 0.8 Vdc.